Create two new layers named Cutting Plane and Hatch Pattern.
AutoCAD- Project Flange Bearing Section
Chapter 8 Projects Project 8.1 -The Tool Holder Directions:
- Create two new layers named Cutting Plane and Hatch Pattern.
- Set the linetype for the Cutting Plane layer to DashedX2 and set the lineweight to .60mm.
- Set the linetype for the Hatch Pattern layer to Continuous and the lineweight to Default. Use the ANSI31 hatch pattern to draw the section lines.
- Save the .dwg file and generate the .pdf drawing.
When you are finished, this drawing file and pdf file will contain the dimensioned multi-views (Top, Side, and Full-section view) and the isometric drawing of the Tool Holder.
© Technical Drawing 101 with AutoCAD Smith & Ramirez –All Rights Reserved
Figure 8.33 3D Sketch of the Tool Holder shown as a Full Section
NOTE: The lines and hatching of the Tool Holder project is added to in Model space. Left-click on the Model tab in the lower-left corner of the screen if it is not already activated.